Environmental Wash System 450

Introducing the ES 450 Wash System

On arrival you will find all necessary parts inside the unit.

First let's see how simply it is to set up this unit

• Filtered outlet holders
• Outlet hose
• Filter bags
• Wash guns and hoses
• Stirring paddle
• Treatment chemical
• Measuring cup for the ES 450

Using the ES 450 Wash System

Place the sludge filter box onto the protruding bolts and tighten with the provided wing nuts.

Now insert the sludge filter bags.

Connect the filter box to the filter line.

Secure using the supplied hose clamp.

The next simply step is to attach the filter hose to the outlet on the filter unit.

Insure that the brass back flow valve is in a vertical position

Simply connect wash hoses to the taps and we are ready to go

Connect town water or recycled water to the system

This system must be installed correctly in accordance with your local regulatory water authority prior to use.

Use the wash area to clean water based paints from brushes and rollers and other equipment. Continue to use the wash until the water level reaches the fill line.

Add part A

Refer to the chemical label for the quantity for your system and then stir.

Add part B

Again refer to the chemical label for the quantity for your system.

And the stir in a circular motion for 1 minute making sure that the stirring paddle reaches the bottom of the holding tank

Leave for one minute and then re-stir.

Notice how quickly the paint is settling to the bottom of the tank.

Full separation can occur in as little as two hours but for best results the system should be left overnight.

Full separation has occurred when the sludge is visible lower than the clean water outlet.

Clean water is then released by opening the clean water outlet allowing the treated water out of the tank via the pre filter, the water treatment filter and the non-return valve to an authorised discharge point.

Turn off the clean water outlet and release the sludge trap.

The paint residue is pumped up through the tube and into the sludge filter bag.

Keep filling the sludge filter bags until all the sludge has been filtered.

To drain the sludge filter box open the filter box drain trap.

Once the filter bags have drained leaving paint waste, discard the paint waste into a suitable container to harden.

Once harden discard the paint as normal refuse.

And there you have it the Environmental Wash System 450.

Don't get fined, go green and stop your pollution

For more information on this product contact your local Dulux trade outlet or Dulux representative.