Environmental Wash System 160

Introducing the Environmental Wash System 160

This system comes ready to use.

Remove the sludge filter bag and the holder prior to use.

Wash tools in the sink provided

Continue to wash equipment until the tank reaches the fill line.

Remove sink and add part A

Refer the chemical label for the correct quantities for you system and then stir

Add part B

Refer the chemical label for the correct quantities for you system quantities and stir in a circular motion.

Leave for 1 minute and then re-stir.

Notice how quickly the paint is settling to the bottom of the tank.

Full separation can occur in as little as 30 minutes but for best results the system should be left for 2 hours. Full separation has occurred when the sludge is visible lower than the clean water outlet.

Clean water is then released by opening the clean water outlet allowing the treated water out of the tank via the water treatment filter and the non-return.

Replace sink, filter bag and holder.

Release the sludge trap.

The paint residue is pumped up through the tube and into the sludge filter bag.

Keep filling the sludge filter bags until all the sludge has been filtered.

Once the filter bags have drained leaving paint waste, discard the paint waste into a suitable container to harden.

Once harden discard the paint as normal refuse.

And there you have it the Environmental Wash System 160.

Don't get fined, go green and stop your pollution

For more information on this product contact your local Dulux trade outlet or Dulux representative.